oreoexchange.blogg.se

1. #Pro tools spectrometer install
2. #Pro tools spectrometer verification
3. #Pro tools spectrometer software
4. #Pro tools spectrometer password

Sampling accessories fit over two alignment pins on the spectrometer baseplate and are held in place by strong magnets.

#Pro tools spectrometer install

To install the optional Everest ATR accessory or iD1 Transmission accessory, grasp the accessory by the front and rear handholds and lower the accessory onto the spectrometer. To run the workflow, touch the Run icon and follow the on-screen prompts. Navigate to the Workflows tab and select Nicolet FTIR - Factory Qualification.

#Pro tools spectrometer verification

Performance verification and qualification workflows use a polystyrene reference material inside the spectrometer to run a series of standard tests to verify your instrument operation and to ensure the accuracy of your data.įor more on performance verification and qualification workflows, see Qualify Your Spectrometer. Run the Nicolet FTIR – Factory Qualification workflow. When calibration is finished, the display shows "Measurement complete" and indicates any change in laser frequency. Laser calibration may take several minutes to complete. Navigate to the Laser Calibration tab and touch calibrate. The alignment process may take several minutes to complete.

#Pro tools spectrometer software

The software displays the connection status in the upper right corner of the screen. Later, you can switch between the touchscreen and desktop interfaces. The first time the software starts, it will open with the touchscreen interface. Launch the Thermo ScientificOMNIC Paradigm software. For best results, re-run steps b and c after the first 12 hours of operation. The instrument takes up to 12 hours to come to thermal equilibrium. The spectrometer's LightBar will display a cycling green light while the instrument warms up and will show a solid green bar when the instrument is ready for use.īefore taking the following steps, make sure there is not a sampling accessory in the sampling compartment. Press the instrument's power button to turn on the spectrometer.Connect the power supply to the spectrometer and to a properly grounded AC power source.

#Pro tools spectrometer password

It is recommended that you leave the password blank during initial setup and later create a secure password and additional user accounts as needed. If this password is lost or forgotten, all data saved on the spectrometer will be unrecoverable. You must create a new password the first time you power on the spectrometer. For instructions on replacing the windows, see Replace the Sample Compartment Windows. If you purchased the ZnSe windows option, replace the windows.

(Optional) Replace the sample compartment windows. If you notice performance issues with your wireless keyboard and mouse, such as lag or delayed or missed input, use the provided USB extension cable to position the wireless USB receiver farther from the USB ports. Some USB and Mini DisplayPort devices are known to interfere with the signal from wireless USB devices, such as wireless keyboards and mice. If you are also using the optional wireless mouse and keyboard, use the provided USB extension cable to position the wireless receiver farther from the USB inputs. If you are using an external monitor, connect the monitor to the spectrometer using the Mini DisplayPort. If you have the attached touchscreen monitor, grasp the monitor by the sides and position it to face the front of the instrument.

Touching the windows could cause permanent damage.